First of all thanks so much for a great program, Tixati is just great!

I added a new category and then set the Outgoing Priority Group for this category to High.

This change is not shown in the Priority column of the existing transfers of this category.
It shows Normal instead of, in this case, N/H.

Maybe I am overlooking something here?

Any suggestions are very welcome!

It's this way, because you can stack (layer) priorities in Tixati. Both priorities from category and individual transfer are applied. For example you can have a high priority category with mixed categories on transfers inside. It works but gets complicated fast. Another reason is it would be misleading with bandwidth limits that are also displayed in priority column. For example it would show the same 100 KB/s limit for each transfer of a category with 100 KB/s limit set, while the limit is for all transfers combined in that category not for each individual transfer.

So short answer is: it works, just isn't displayed in a column, there is always per transfer priority in that column.

Thank you very much Pete for your clear reply.